Support & Videos

Safety Advice

SAFETY NOTICE: QR + SAFETY LINE
Safety notice regarding care and maintenance of the Sensor 2S bar
 
Ensure all safety mechanisms including the safety line and the tube it travels through are free of sand and fully functional before every launch.Rinse your Sensor 2S bar with fresh water after every use. While rinsing, release the chickenloop and feed the safety line back and forth through the stainless steel tube to remove any potential debris. Inspect the Rotor quick release, safety line movement, and ceramic bearings and clean if required.
Sicherheitshinweise QR + Safety Line

SENSOR 3 Bar Systems

Full Bar REPLACEMENt 

How to replace your control bar.
Sensor 3, Sensor 3 Pro

bar insert Replacement

 How to replace your bar inserts.
Sensor 3, Sensor 3 Pro
 

Bar Width adjustment

How to change your bar width on your Sensor Sensor 3, Sensor 3 Pro
 

SENSOR 2 Bar Systems

line length check and adjustment 

How to check and adjust line length on a Sensor bar.
Sensor 2, Sensor Pro, Sensor 2S/2S+, Sensor 2S Pro

CHICKEN Loop REPLACEMENt

How to replace the chicken loop.
Sensor 2, Sensor Pro, Sensor 2S/2S+, Sensor 2S Pro

Chicken Stick REPLACEMENT 

How to replace the chicken stick.
Sensor 2, Sensor Pro, Sensor 2S/2S+, Sensor 2S Pro

Kite BLADDER REPLACEMENT

Bladder-Bezeichnung
BLADDER

All leading edge and strut bladders are available as single parts.

STRUT BLADDER REPLACEMENT

Section 1: Chris shows how to remove a fast pump strut bladder and how to put in again.

LEADING EDGE BLADDER REPAIR

Section 2: Chris Bösch demonstrates the repair procedure of the inflatable leading edge.

BLADDER REPAIR

Section 3: Chris shows how to find the air leak and the detailed procedure of a bladder repair. He is using the always included Repair Kit Pro.



 

You didn't find what you were looking for?


Check our knowledge base to find an answer.

Send us a message or call us on +49 4371 88934-0 and we're happy to help you out!